SJET - Solar Jet Pump
DC Solar Self-priming Pump
SJET Series Solar Jet Pump
Permanent magnet brushless DC Solar water Pump
DC72V Solar pumping system
Power range:550 - 750w
Head range:45 - 55m
Flow range:2.7 - 3m3/h
Requiring the quantity of solar panel from 3 - 4 pieces
Poly / Mono 250/300 watt solar panel
DC Solar surface pumps are fitted with a permanent magnet,brushless
Which enables the efficient use of energy from a wide range of
The pump system offers the perfect water supply solution.
This project products are mainly used in dry irrigation of
It can be used for drinking water and living water.
The living condition could be much improved.
1. Permanent magnet,brushless motor,saving energy and offering
2. NSK bearing with alloy mechanical seal,offering the longer
3. MPPT function offers higher utilization rate of solar energy.
4. Water proof and leak proof based on double water seal.
5. Controller maximum's operating temperature:60℃
6. Featured function:MPPT function,Soft start function,Dry running
protection,Adjustable speed function,
Error wiring protection,Over/under-voltage protection,Overload
phase-loss protection,High working temperature protection
1.Power Supply:1.Solar panel | 2.Storage batteries.
DC72 Solar pumps:63-150V (VMP)
3.PH value 6.5 ~ 8.0
What is solar SJET solar pump?
HYBSUN SJET series solar self-priming pump which get the power from
the sun, you will never have an electric bill,SJET series solar
self-priming pump can not only be used for household drinking
water, but for animal husbandry and irrigation of small farms.Which
is designed to lift water from some level below the pump suction
without having to fill the suction piping with liquid.It
accomplishes this by creating a partial vacuum at the pump suction
which removes the air from the suction line.The pump then releases
the entrained air through it's discharge while retaining the
initial fill of water in the pump case.This air/water separation is
what makes the self primer different.Try this with a standard end
suction centrifugal and all you will get is a slug of water.
What components does HYBSUN SJET solar series self-priming pump
HYBSUN solar SJET series self-priming pump consists of PPO
impeller,SS304 pump head,Aluminum pump casing,Brushless DC
motor(BLDC motor),3 meters,3 cores,1.5mm2 cable and controller with
installation tools.As accessories which include float
switch,non-return valve,shrinkable tubes,adhesive tape,operation
What are the advantages of HYBSUN BLDC motor?
HYBSUN BLDC motor which mainly consists of stator and rotor.For the
stator which consists of silicon steel sheet & high temperature
copper wire.Whose the max temperature is 180 degrees. All winding
automatically by machine,which can produce about 2000 pieces per
day.For the rotor which includes NSK bearing,SS 304 shaft and 40SH
magnet.Whose the max temperature is 150 degrees.
What are the advantages of HYBSUN solar pump controller?
Maximum Power Point Tracking is electronic tracking - usually
digital.The charge controller looks at the output of the panels and
compares it to the battery voltage.It then figures out what is the
best power that the panel can put out to charge the battery.It
takes this and converts it to best voltage to get maximum AMPS into
the battery. (Remember, it is Amps into the battery that counts).
Most modern MPPT's are around 93-97% efficient in the
conversion.You typically get a 20 to 45% power gain in winter and
10-15% in summer.Actual gain can vary widely depending weather,
temperature,battery state of charge,and other factors.
Soft start function
HYBSUN controller control the the motor operation continues,operating power is gradually increased until motor reaches it;s maximum
speed.As a result,service lifetime of both the motor and controller
and protection switch gear and prolonged.
Dry running protection
HYBSUN solar surface pump’s controller that offers intelligent
detection function.Pump will be automatically power off once
running without water for 30s.
HYBSUN solar controller with adjustable speed function.User could
set different working speed to adjust water capacity and head
according actual water demand to avoid water waste. Meanwhile,which
also reduces the mechanical wear of the motor as well as the start
up loads on the PV array
Error wiring protection
High working temperature protection
What are the advantages of HYBSUN impeller?
HYBSUN use PPO impeller which is one of the most important
engineering plastics due to its high strength, high heat distortion
temperature, and high chemical resistance,Because of its unique
combination of high mechanical property, low moisture absorption,
excellent electrical insulation property, excellent dimension
stability, and inherent flame resistance.
How long is the warranty of HYBSUN solar SJET solar pump?
Hereby guarantee that HYBSUN solar SJET solar pumps are guaranteed
against defects in material and technology for 24 months beginning
from the date of shipping the goods from factory.Within this
period,adjustment,repair or replacement of parts or whole will be
performed without charge except in the case of damage caused by
accidents,misuse,tampering or lack of care.
Not under warranty
1)Defects caused by the owner's neglect of instructions in the
manual before operation or misuse of the pump.
2).Operation on higher/lower voltage than specified,tampering with
electrical system,voltage surges as a result of lightening or
faulty electrical supply.
3).Any damage caused by natural disasters,such as fire,flood or
4).The pump tampered with or damaged by any non-authorized
5).Maximum fluid temperature exceed 35℃.
6).Maximum sand content exceed 0.25%.
7).Putting water inside the controller by user.
What is the standard delivery time?
HYBSUN always insists to provide best service,the delivery time is
about 2 weeks.
Where is the loading port?
HYBSUN could according your demand to select the loading
port,Normally we choose Ningbo port.